TW1 Thermocouple Catalog Page

Mineral Insulated Thermocouples with Coil Cord
(Series TW1)

Ordering Information

Configure this style to request a quote or call for assistance

Part No.:

select options

Start Here

1
Series
2
Calibration
3
Sheath Diameter
4
Sheath Material
5 6
Sheath Length
7
Junction
8
Transition Fitting
9
Coil Cord Style
10
Termination Style
11
Special Features
TW1

2 Calibration
J Type J
K Type K
T Type T
E Type E
W Type J (Special limits)
X Type K (Special limits)
Y Type T (Special limits)
Z Type E (Special limits)

3 Sheath Diameter
D 0.062" (1.6mm)(1/16")
E 0.079" (2mm)
F 0.092" (2.3mm)
G 0.118" (3mm)
H 0.125" (3.2mm) (1/8")
J 0.156" (4mm)
K 0.177" (4.5mm)
L 0.188" (4.8mm) (3/16") (standard)
M 0.236" (6mm)
N 0.250" (6.4mm) (1/4")
  Sizes for reference only (Standard tolerances apply)
  For other diameters consult factory

4 Sheath Material
F 304 SS
H 316 SS
M INCONEL (600)
N 446 SS
P 310 SS
Q Hastelloy
R Pyrosil D

5 6 Sheath Length
¼-600

7 Junction
G Grounded (Single)
U Ungrounded (Single)
E Exposed (Single)
R Exposed & recessed (Single)

8 Transition Fitting
1 3/8”OD X 1.25” w/ strain relief spring
2 1/4”OD X 1.25” w/ strain relief spring
4 3/8”OD X 1.25” (no spring)
5 1/4”OD X 1.25” (no spring)
  500°F epoxy standard

9 Coil Cord Style
N 10" coil cord (extends to approx. 6ft) (220°F)
P 24" coil cord (extends to approx. 14ft) (220°F)

10 Termination Style
A 2" stripped leads (bare ends)
B 2" stripped leads w/ spade lugs
C Standard male plug (400°F)
G Solid pin plug
H Standard female jack (400°F)
J Miniature plug (400°F)
K Miniature jack (400°F)
L 2" stripped leads w/ #6 Ring terminals
W 2” stripped leads w/ pin terminals
Q 2” stripped leads w/ wire ferrules

11 Special Features
  None
05 Drill point tip
07 Cable Clamp
08 Bx Connector
09 Mating connector
18 Moisture protection boot on connector
24 Fluoropolymer covered probe