Multipoint Thermocouples
(Series TMP1)
Ordering Information
Configure this style to request a quote or call for assistance
Part No.:
select options
Start Here
| 1 Series |
2 Calibration |
3 Sheath Diameter |
4 Sheath Material |
5 6 Sheath Length |
7 Junction |
8 Transition Fitting |
9 Lead Wire Material |
10 Lead Wire Length |
11 Termination Style |
12 Points |
|---|---|---|---|---|---|---|---|---|---|---|
| TMP1 | X |
| 2 | Calibration |
|---|---|
| J | Type J |
| K | Type K |
| W | Type J (Special limits) |
| X | Type K (Special limits) |
| 3 | Sheath Diameter |
|---|---|
| H | 0.125" (3.2mm) (1/8") |
| L | 0.188" (4.8mm) (3/16") (standard) |
| N | 0.250" (6.4mm) (1/4") |
| Sizes for reference only (Standard tolerances apply) | |
| For other diameters consult factory |
| 4 | Sheath Material |
|---|---|
| F | 304 SS |
| H | 316 SS |
| M | INCONEL (600) |
| 5 6 | Sheath Length |
|---|---|
| ¼-600 |
| 7 | Junction |
|---|---|
| G | 
Grounded (Single) |
| U | 
Ungrounded (Single) |
| 8 | Transition Fitting |
|---|---|
| X | 18mm OD X 5” long |
| 9 | Lead Wire Material |
|---|---|
| A | 
Fiberglass (800°F) |
| B | 
Fluoropolymer (400°F) |
| C | 
Polyimide (500°F) |
| Wire gauge determined by ECS based on sheath diameter |
| 10 | Lead Wire Length |
|---|---|
| 6-300 | |
| Over 300" contact factory |
| 11 | Termination Style |
|---|---|
| A | 
2" stripped leads (bare ends) |
| B | 
2" stripped leads w/ spade lugs |
| C | 
Standard male plug (400°F) |
| G | 
Solid pin plug (400°F) |
| H | 
Standard female jack (400°F) |
| J | 
Miniature plug (400°F) |
| K | 
Miniature jack (400°F) |
| W | 
2” stripped leads w/ pin terminals |
| Q | 
2” stripped leads w/ wire ferrules |
| 12 | Number of Points |
|---|---|
| 1-10 |
| Point Locations (from tip) | |
|---|---|
| 1 | |
| 2 |
